![]() ![]() (If two devices on the SCSI chain have the same ID number, there will be a conflict and your system will not function correctly.) Higher numbered devices have higher priority- get 'looked for' first- so, it is standard practice to set the device you boot from to 6 or 7. Each device should have its own, unique ID number in the range 0-7. SCSI ID numbers identify devices on the SCSI chain. This provides a write-able medium for saving SCSI interface card setup parms. Note: If you want your system to include a SCSI CD-ROM drive, it is best to have a SCSI Zip Drive or SCSI hard disk connected to the SCSI interface, too. Of course, you will still need to add a SCSI interface card if you want to connect a SCSI CD-ROM and/or Zip Drive. The IDE hard card approach offers speed and capacity comparable to SCSI, very easy installation, and, it eliminates hassles with external boxes and cables. SHH Systeme offers the FileCard (about $170 + cost of drive) as well as a series of IDE controller cards to which you can add a 2.5" IDE drive (about $120-$170 including mounting kit). 60MB for $99) with system software installed. Alltech sells the Focus Hard Card in varying sizes (e.g. This "hard card" plugs into a Slot- usually Slot 7. SCSI interface cards which do not supply termination powerĪnother way to go is a 2.5" IDE drive mounted on an IDE interface card. switchable termination power (on/off) is a plus for users of no or switchable termination (use an external terminator at allows up to 20 (?) partitions per driveįor the hard drive itself, look for a SCSI drive in an external enclosure with the following features: allows over 100 partitions to be active at any one time allows up to 7 devices to be added to the chain does not allow partitions to be mapped in ProDOS ![]() does not provide termination power to the SCSI chain (can be no longer produced or supported by Apple allows up to 12 partitions to be active at any one time allows up to 8 devices to be added to the chain device drivers come on the card in the upgradeable ROM chip allows partitions to be mapped in ProDOS provides termination power to the SCSI chain faster than Apple Hi-Speed, especially in ProDOS The next best card is the Apple Hi-Speed SCSI card. The preferred SCSI card is the RamFAST Rev. Insert the card in a slot, connect a cable or two, and change a slot setting. Hard drives, cd-rom drives, removable media (SyQuest, Iomega), flopticals, and scanners all can be added to the SCSI chain. The most versatile and most common hard drive set-up is an internal SCSI interface card and an external SCSI drive. Usually, you will need to insert an interface card, possibly connect a cable or two, and change a Slot setting in the Control Panel Desk Accessory.Ġ02- What kinds of hard drive systems are available for Apple II users? ![]() A fix?Ġ23- Where can I find the RamFAST manual on the net?Ġ24- How can I tell which Apple SCSI card I have?Ġ25- Where can I find Profile maintenance and formatting info?Ġ01- How difficult is it to add a hard drive to my IIGS?Īdding a hard drive is not much of a problem. How do I install System 6.0.1?Ġ21- How is DMA set for SCSI cards with 8MB RAM cards on the GS?Ġ22- My 20MB Focus bombs and there's some goo on the card. for a Bernoulli drive?Ġ13- What are the settings for a CMS hard drive controller card?Ġ14- Does it matter when I power-ON my SCSI hard disk?Ġ15- Can I leave SCSI devices I'm not using turned OFF?Ġ16- Is there a generic SCSI tutorial available for downloading?Ġ17- What is the correct time-out setting for a Focus hard drive?Ġ18- How do I modify my Apple HSS card to supply Termination Power?Ġ19- Can I get a Focus drive bigger than a couple hundred MB?Ġ20- My hard disk is on a CMS SCSI. C SCSI Card work with a SCSI-2 drive?Ġ08- Can I avoid the "RamFAST/SCSI is searching SCSI bus" delay?Ġ09- What is the pinout for the standard 50-pin SCSI cable?Ġ10- What's the SCSIHD.DRIVER patch to ignore DRIVER43 partitions?Ġ11- What is the "bad bug" in the ROM 3.01e RamFAST?Ġ12- What are correct HS SCSI settings, etc. Administrator: Steve NelsonĬsa2 FAQs-on-Ground ref: Csa2HDNSCSI.txt rev115 October 2007Ġ01- How difficult is it to add a hard drive to my IIgs?Ġ02- What kinds of hard drive systems are available?Ġ04- What is "SCSI-2" and how is it different from SCSI-1?Ġ05- Will a SCSI-2 hard drive work with an Apple II system?Ġ06- Will my Rev. The 2 Usenet newsgroup Apple II FAQs originate from Apple II Csa2 FAQs: Hard Disks & SCSI, Part 12/25
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |